Subaru Crosstrek Service Manual: Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)
REMOVAL
CAUTION:
Be careful not to damage the sensors and interior trims when removing.
1. Disconnect the ground cable from battery. NOTE">
2. Remove the sunload sensor.
(1) Release the connectors and claws, and then remove the grille - front defroster.
(2) Press the left and right claws to remove the sunload sensor from the grille - front defroster.
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)INSPECTION1. Check if there is anything that affects sensing, around the sunload sensor.(1) Is the sunload sensor free from ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Sunload Sensor (Auto A/C Model)INSTALLATIONInstall each part in the reverse order of removal. ...
Other materials:
Connecting a trailer
Ball mount
Hitch pin
Safety pin
Hitch receiver tube
1. Insert the ball mount into the hitch
receiver tube.
2. Insert the hitch pin into the hole
located on the hitch receiver tube so that
the pin passes through the ball mount.
3. Insert the safety pin through the hole
locat ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof AssemblyREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• When removing the c ...
Handling of radar sensors
Radar sensors
The radar sensors, one on each side of
the vehicle, are mounted inside the rear
bumper.
CAUTION
To ensure correct operation of the
BSD/RCTA, observe the following
precautions.
Always keep the bumper surface
near the radar sensors clean
Do not affix any stickers o ...
