HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > In-Vehicle Sensor (Auto A/C Model)
REMOVAL
CAUTION:
Be careful not to damage the sensors and interior trims when removing.
1. Disconnect the battery ground cable and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver INN. Instrument Panel Lower Cover > REMOVAL">
3. Remove the in-vehicle sensor.
(1) Disconnect the connector, and remove the aspirator hose.
(2) Release the claws and remove the cover switch - starter.
(3) Remove the screw and remove the in-vehicle sensor from the cover switch - starter.
Control module i/o signal Electrical specification
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Combination meterTerminal No.ContentTerminal No.Content1Security indicator27Ambient sensor2Charge warning light28UART (MFD)3Oil pressure warning light29Steering switch (+)4RH turn indicator30Pedes ...
Inspection
DIFFERENTIALS > Rear Differential (T-type)INSPECTIONWash all the disassembled parts clean, and examine them for wear, damage and other defects. Repair or replace the defective parts as necessary.1. Hypoid driven gear and drive pinion• If there is evidently an abnormal tooth contact, find ou ...
Replacement
DIFFERENTIALS > Differential Gear OilREPLACEMENTCAUTION:• Gear oil is extremely hot just after driving. Be wary of receiving burns.• Be careful not to spill the differential gear oil on exhaust pipe. If gear oil is spilled, wipe it off completely.1. Lift up the vehicle.2. Remove the d ...