Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater and Cooling Unit

REMOVAL

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">

3. Drain the coolant from the radiator. Engine Coolant > REPLACEMENT">

4. Remove the air intake boot. Air Intake Boot > REMOVAL">

CAUTION:

Move aside the air intake boot to perform the operation without disconnecting the PCV hose.

5. Remove the clips and bolts, and remove the hose - pressure suction and the pipe - evaporator cooling from the expansion valve - cooling.

CAUTION:

Seal the disconnected hose, pipe and engaging part of expansion valve with a plug or vinyl tape to prevent foreign matter from entering.

6. Loosen the heater hose clamps and detach the hoses.

NOTE:

Put alignment marks to hoses, clamps, etc.

7. Remove the instrument panel assembly. Instrument Panel Assembly > REMOVAL">

8. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">

9. Remove the blower motor unit assembly. Blower Motor Unit Assembly > REMOVAL">

10. Remove the heater and cooling unit assembly.

(1) Disconnect each connector and the hose - drain.

(2) Remove the bolt and nuts, and remove the heater & cooling unit assembly.

Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater and Cooling UnitINSTALLATIONCAUTION:• Replace O-rings with new parts and install securely.• Before handling the airbag system component ...

Heater core
...

Other materials:

Electrical component location Location
LAN SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)VDC CM(7)Combination meter(12)Data link connector(2)Power steering CM(8)A/C control panel(13)Transmission CM(3)Stereo camera(9)MFD(14)Airbag CM(4)Radar sensor LH(10)Data communication module (DCM)(15)Engine CM(5)Auto headlight bea ...

Installation
REAR SUSPENSION > Rear Trailing LinkINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Install each part in the reverse order of removal.Tighten ...

Preparation tool
LIGHTING SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “A ...

© 2016-2024 Copyright www.sucross.com