Subaru Crosstrek Service Manual: Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion Valve
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">
3. Remove the air intake boot. Air Intake Boot > REMOVAL">
CAUTION:
Move aside the air intake boot to perform the operation without disconnecting the PCV hose.
4. Remove the expansion valve - cooling.
(1) Remove the clips and bolts, and detach the hose - pressure suction and the pipe - evaporator cooling.
CAUTION:
Seal the disconnected hose, pipe and engaging part of expansion valve with a plug or vinyl tape to prevent foreign matter from entering.
(2) Remove the bolt, and remove the expansion valve - cooling.
CAUTION:
Seal the pipe and engaging part of expansion valve with a plug or vinyl tape to prevent foreign matter from entering.
Preparation tool:
Hexagon wrench: 4 mm (0.16 in)
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Expansion ValveINSTALLATIONCAUTION:Replace the O-rings with new parts, and then apply compressor oil.1. Install each part in the reverse order of removal. ...
Other materials:
Inspection
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with PhenomenonINSPECTION(1) Perform the diagnosis according to the diagnostic procedure of the corresponding symptom that is shown in the symptom list.(2) If there are multiple symptoms, perform the diagnosis in the symptom sequence (1 > 2 &g ...
Disassembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingDISASSEMBLYUsing the ST or a hydraulic press, push out the hub bolt (b) from the rear hub unit bearing (a).CAUTION:• Be careful not to hammer the hub bolts. This may deform the hub unit bearing.• Do not reuse the hub bolt.NOTE:Since the rear h ...
Inspection
GLASS/WINDOWS/MIRRORS > Rear Window Defogger SystemINSPECTION1. CHECK SYSTEMSymptomsInspection orderRear window defogger does not operate.(1) Check the fuse.(2) Check the rear defogger relay.(3) Check the rear window defogger switch.(4) Check the heat wire.(5) Check the wiring harness.(6) Check b ...
