Subaru Crosstrek Service Manual: Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator Sensor
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
3. Remove the evaporator assembly - cooling. Evaporator > REMOVAL">
4. Remove the thermostat - cooling from the evaporator assembly - cooling.
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSPECTION1. MANUAL A/C MODELWIRING DIAGRAM:1. Prepare the vehicle.NOTE:Check that the ambient temperature is 25 — 40°C (77 ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator SensorINSTALLATIONCAUTION:• Make sure that the water seal packing on the cover attachment area is securely attached.• Replace the O ...
Other materials:
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Low tire pressure warning light (type A)
Low tire pressure warning light (type B)
The tire pressure monitoring system provides
the driver with a warning message
when tire pressure is severely low.
The tire pressure monitoring system will
activate only when the vehicle is driven at
s ...
General diagnostic table Inspection
CLUTCH SYSTEM > General Diagnostic TableINSPECTION1. CLUTCHSymptomsPossible causeCorrective action1. Clutch slippageIt is hard to perceive clutch slippage in the early stage, but pay attention to the following symptoms.• Engine temporarily speeds up when the accelerator ON immediately after ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Control Module (ECM)INSTALLATIONInstall in the reverse order of removal.CAUTION:• When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system.• For model without keyless access with pu ...
