HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Evaporator
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Using the refrigerant recovery system, discharge refrigerant. Refrigerant Recovery Procedure > PROCEDURE">
3. Remove the air intake boot. Air Intake Boot > REMOVAL">
CAUTION:
Move aside the air intake boot to perform the operation without disconnecting the PCV hose.
4. Remove the expansion valve - cooling. Expansion Valve > REMOVAL">
5. Remove the glove box. Glove Box > REMOVAL">
6. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">
7. Remove the blower motor unit assembly. Blower Motor Unit Assembly > REMOVAL">
8. Remove the evaporator assembly - cooling.
(1) Disconnect the connector and lock of the thermostat - cooling.
(2) Remove the screws and detach the cover.
(3) Remove the cover - heater unit.
1. Disconnect the connector for the power transistor or resistor.
2. Remove the screws and clips to remove the cover - heater unit.
(4) Remove the bolt, and detach the pipe - evaporator core.
CAUTION:
Seal the disconnected pipe and engaging part of evaporator assembly with a plug or vinyl tape to prevent foreign matter from entering.
Preparation tool:
Hexagon wrench: 4 mm (0.16 in)
(5) Pull out the evaporator assembly - cooling from the case - heater unit.
(6) Remove the thermostat - cooling from the evaporator assembly - cooling.
Removal
REAR SUSPENSION > Rear Shock AbsorberREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the sensor assembly - headlight beam leveler. (Model with auto headlight beam leveler, left side only)CAUTION ...
Note
GLASS/WINDOWS/MIRRORS > Power Window SystemNOTEFor operation procedures of each component of the power window system, refer to the respective sections.• Power window control switch: Power Window Control Switch">• Front door glass: Front Door Glass">• Front regu ...
Engine low oil level warning light
This
light illuminates when the engine oil
level decreases to the lower limit.
If the engine low oil level warning light
illuminates while driving, park the vehicle
in a safe and level location, and then
check the engine oil level. When the
engine oil level is not within the normal
rang ...