HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control Panel
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">
3. Remove the knee airbag module. Knee Airbag Module > REMOVAL">
4. Remove the glove box. Glove Box > REMOVAL">
5. Remove the center grille assembly. Air Vent Grille > REMOVAL">
6. Remove the audio assembly or navigation assembly. Audio > REMOVAL">
7. Remove the screws to remove the heater control assembly.
NOTE:
For manual A/C model, refer to the instructions above to remove.
Tool locations
Jack handle
Tool bucket
Spare tire
Wheel nut wrench
Screwdriver
Jack
Towing hook (eye bolt)
A jack handle is stored under the floor of
the cargo area. A jack and a towing hook
are stored in the tool bucket that is located
in the recess of the spare tire wheel.
Als ...
Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering WheelINSPECTION1. PADDLE SHIFT SWITCHCheck the resistance of paddle switch.STEPCHECKYESNO1.SHIFT-UP SWITCH CONTINUITY CHECK.1) Operate the + side of paddle shift assembly and hold it.2) Measure the resistance between terminals of the paddle shift ...
Dtc p0516 battery temperature sensor circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0516 BATTERY TEMPERATURE SENSOR CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATIO ...