HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Resistor (Manual A/C Model)
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the glove box. Glove Box > REMOVAL">
3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">
4. Remove the resistor.
(1) Disconnect the connector.
(2) Remove the screw and remove the resistor.
Air conditioner control
The air conditioner operates only when
the engine is running.
Press the air conditioner button while the
fan is in operation to turn on the air
conditioner. When the air conditioner is
on, the "A/C" indicator light illuminates.
To turn off the air conditioner, press the
button again.
NOT ...
Replacing bulbs
WARNING
Bulbs may become very hot while
illuminated. Before replacing bulbs,
turn off the lights and wait until the
bulbs cool down. Otherwise, there is
a risk of sustaining a burn injury.
CAUTION
Replace any bulb only with a new
bulb of the specified wattage.
Using a bulb of differe ...
Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system compone ...