HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower Motor Unit Assembly
REMOVAL
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the glove box. Glove Box > REMOVAL">
3. Remove the engine control module (ECM). Engine Control Module (ECM) > REMOVAL">
4. Remove the blower motor unit assembly.
(1) Release the claws, and then remove the grille assembly - ventilation RH.
(2) Disconnect the blower motor relay and each connector.
(3) Remove the bolts and nuts to remove blower motor unit assembly.
NOTE:
Remove the RH upper nut from the mounting portion of the grille assembly - ventilation RH.
Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
"On" to activate the screens. Select "Off"
to deactivate the screens.
Gauge Initial Movement
The movement of the m ...
Specification
LIGHTING SYSTEM > General DescriptionSPECIFICATIONNo.DescriptionCapacity and wattageType(1)HeadlightLow beam (halogen type)12 V — 55 WH11Low beam (HID type)12 V — 35 WD2RHigh beam12 V — 60 WHB3Front turn signal light12 V — 21 WWY21WParking light12 V — 5 WW5WSide marker light12 V — 5 W ...
Rear tie-down holes
Rear tie-down hole
The rear tie-down holes are located near
each of the jack-up reinforcements.
There is a plug in each rear tie-down hole.
To use the rear tie-down holes, remove
the plugs. After using the rear tie-down
holes, return the plugs to their original
places.
WARNING
...