Subaru Crosstrek Service Manual: Removal

Subaru Crosstrek Service Manual / Hvac system (heater, ventilator and a/c) / Air mix door actuator / Removal

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door Actuator

REMOVAL

1. LH

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL">

3. Remove the knee airbag module. Knee Airbag Module > REMOVAL">

4. Remove the motor - actuator mix.

(1) Disconnect the connector, and remove the rod from the rod clamp.

(2) Remove the screws and detach the motor - actuator mix.

2. RH

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the glove box. Glove Box > REMOVAL">

3. Remove the motor - actuator mix.

(1) Disconnect the connector, and remove the rod from the rod clamp.

(2) Remove the screws and detach the motor - actuator mix.

Inspection

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the tempe ...

Installation

HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door ActuatorINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” ...

Other materials:

Command list
Recognizable voice commands and their actions are shown below. NOTE Some voice commands may not be available depending on the market, vehicle specifications or the device connection status. Frequently used commands are listed in the following tables. For devices that are not instal ...

List of diagnostic trouble code (dtc) List
BODY CONTROL SYSTEM (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTDTCItemContent of diagnosisNoteB1010BODY CONTROL SYSTEM (BIU) MALFUNCTIONBody integrated unit internal error Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1010 BODY CONTROL SYSTEM (BIU) MALFUNCTION&qu ...

Assembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingASSEMBLY1. Install the rear hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)(1)Rear hub unit bearing2. Using a press, press new hub bolts (b) until their seating surfaces contact the rear hub unit bearing (a).NOTE:Use the 12 ...