Subaru Crosstrek Service Manual: Removal

1. Disconnect the ground cable from battery. NOTE">

2. Remove the trim panel - rear door. Door Trim > REMOVAL">

3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">

4. Attach the battery ground cable and the switch - power window, and turn the ignition switch to ON.

5. Remove the glass assembly - rear door.

(1) Operate the switch - power window sub rear to move the glass assembly - rear door to the lowest position.

(2) Remove the running channel - rear door.

(3) Remove the screws and bolts, and then remove the sash COMPL - rear partition.

(4) Remove the glass - rear door partition.

(5) While tilting the glass assembly - rear door, remove the guide from the roller of the regulator and motor assembly - rear, then remove the glass assembly - rear door.

CAUTION:

Avoid impact and damage to the glass assembly - rear door.

Installation

Rear gate glass

Other materials:

Condition check
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTFCONDITION CHECKNOTE:When replacing CVTF, determine the condition inside the transmission body by inspecting the drained CVTF.Fluid conditionTrouble and possible causeCorrective actionMetal particles.Excessive wear of the internal of the transmission ...

Removal
SECURITY AND LOCKS > Starter Cut RelayREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait fo ...

Dtc p0604 internal control module random access memory (ram) error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERRORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine does not start• Engine stallCAUTION:After servicing or ...