Subaru Crosstrek Service Manual: Removal
GLASS/WINDOWS/MIRRORS > Power Window Control Switch
REMOVAL
1. MAIN SWITCH
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the panel - power window main switch.
CAUTION:
Be careful not to damage the trim panel - front door with the panel - power window main switch.
(1) Insert a sheet of protective paper (a) between panel - power window main switch and trim panel - front door.
(2) Remove the screws and disconnect the connector.
(3) Release the claws, and then remove the panel - power window main switch.
(4) Release the claws, and then remove the switch - power window main.
2. SUB-SWITCH
Switch - power window sub front
For removal of the switch - power window sub front on the passenger’s seat, refer to the removal procedure of the switch - power window main. Power Window Control Switch > REMOVAL">
Switch - power window sub rear
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - rear door. Door Trim > REMOVAL">
3. Remove the panel - power window sub switch rear.
CAUTION:
Be careful not to damage the trim panel - rear door with the panel - power window sub switch rear.
(1) Insert a sheet of protective paper (a) between panel - power window sub switch rear and trim panel - rear door.
(2) Remove the screws and disconnect the connector.
(3) Release the claws, and then remove the panel - power window sub switch rear.
4. Release the claws, and then remove the switch - power window sub rear.
Inspection
GLASS/WINDOWS/MIRRORS > Power Window Control SwitchINSPECTION1. MAIN SWITCH• Driver’s seatCAUTION:Since the switch - power window main is controlled by CPU, do not check continuity for ...
Installation
GLASS/WINDOWS/MIRRORS > Power Window Control SwitchINSTALLATIONCAUTION:• After installing the switch - power window main, always perform the initial setting.Failure to do so may cause the imp ...
Other materials:
Dtc b19f0 short in front p/t 2 rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F0 SHORT IN FRONT P/T 2 RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is shorted.• Lap seat belt pretensioner (RH) is faulty.• ...
Dtc c1424 ecm
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1424 ECMDTC detecting condition:ECM malfunctioningTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.STEPCHECKYESNO1.CHECK E ...
Dome light
ON
DOOR
OFF
The dome light switch has the following
positions.
ON: The light remains on continuously.
OFF: The light remains off.
DOOR: The dome light illuminates automatically
in the following cases.
Any of the doors or the rear gate is
opened.
The doors or the rear g ...
