Subaru Crosstrek Service Manual: Removal
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor Assembly
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
4. Remove the glass assembly - front door. Front Door Glass > REMOVAL">
5. Remove the regulator and motor assembly - front.
(1) Disconnect the motor - front connector.
(2) Remove the bolts, and then remove the regulator and motor assembly - front.
Inspection
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor AssemblyINSPECTION1. Disconnect the connector of the motor - front.2. Check the motor operation when battery voltage is applied between terminals o ...
Installation
GLASS/WINDOWS/MIRRORS > Front Regulator and Motor AssemblyINSTALLATIONInstall each part in the reverse order of removal.Tightening torque:Refer to “COMPONENT” of “General Descript ...
Other materials:
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseASSEMBLY1. Face the O-ring side of the CVTF filter to the transmission case side, and install the CVTF filter.NOTE:Apply CVTF to the O-ring of CVTF filter.2. Install the CVTF filter cover and gasket.NOTE:Use a new gasket.Tightening torq ...
Dtc c1251 wheel speed sensor system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1251 WHEEL SPEED SENSOR SYSTEMNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Installation
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyINSTALLATION1. Before installation, check the following items.• Lever is free from deformation.• Grease is applied sufficiently to lever joints.If grease is insufficient, add it as necessary before assembling.• ...
