GLASS/WINDOWS/MIRRORS > Front Door Glass
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
4. Remove the front door inner pad (a).
CAUTION:
If the clip is damaged, replace it with a new part because the panel assembly - front door may be deformed.
5. Attach the battery ground cable and the switch - power window, and turn the ignition switch to ON. NOTE">
6. Remove the glass assembly - front door.
(1) Operate the switch - power window to move the glass assembly - front door to the position where the mounting bolts can be seen.
(2) Remove the running channel - front door.
(3) Remove the mounting bolts from the glass assembly - front door.
(4) While tilting the glass, remove the glass assembly - front door.
CAUTION:
Avoid impact and damage to the glass assembly - front door.
7. Remove the glass - front door partition.
(1) Remove the bolts and screws, and then remove the sash COMPL - partition.
(2) Remove the glass - front door partition.
Inspection
BRAKE > Stop Light SwitchINSPECTION1. CLEARANCE CHECKNOTE:Check for clearance is applied only to LED model.1. Measure the clearance between the end of the stop light switch and the stopper.Specification:Clearance (A) of the stop light switch: 1 mm — 2 mm (0.04 in — 0.08 in)(a)Stop light switc ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Level SensorINSPECTION1. Check that the fuel level sensor has no damage.2. Measure the fuel level sensor float position.NOTE:When inspecting the fuel level sensor, perform the work with the sensor installed to the fuel pump.(1)FULL(2)EMPTY(3)Fuel tank se ...
Location
EyeSight > Relay and FuseLOCATIONRelay & fuse boxFuse 10 A (stop light and brake switch, brake light relay)(A)Relay holderBrake light relay(B)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"> ...