Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve Assembly

REMOVAL

1. Release the fuel pressure. Fuel > PROCEDURE">

2. Disconnect the ground cable from battery.

3. Remove the intake manifold. Intake Manifold > REMOVAL">

4. Disconnect the connector (A) from the tumble generator valve assembly.

5. Remove the tumble generator valve assembly from the cylinder head.

RH side

LH side

6. Remove the cylinder head plate from cylinder head.

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyINSPECTION1. CHECK MOTOR1. Connect the battery positive terminal to terminal No. 5 and the battery ground terminal to terminal N ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve AssemblyINSTALLATIONInstall in the reverse order of removal.NOTE:Use a new gasket.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb ...

Other materials:

Rear wiring harness and rear gate cord Location
WIRING SYSTEM > Rear Wiring Harness and Rear Gate CordLOCATIONConnectorConnecting toNo.PoleColorAreaNo.DescriptionR163C-4 Rear door switch RHR223C-2 Rear door switch LHR2510BlackC-2 Radar sensor LH (master)R266GrayC-5 Rear combination light RHR286GrayC-3 Rear combination light LHR293BlackD-2 Rear ...

Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid sprays until you release the lever. The wipers operate while you pull the lever. NOTE Windshield washer fluid warning light (type A) Windshield washer fluid warning light (type B) The windshield wash ...

Inspection
COMMUNICATION SYSTEM > Horn SystemINSPECTIONSymptomsInspection stepsHorn does not sound1. Check the fuse.2. Check the horn relay.3. Check the role connector.4. Check the horn switch.5. Check the horn assembly.6. Check the harness. ...

© 2016-2024 Copyright www.sucross.com