Subaru Crosstrek Service Manual: Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve Actuator
REMOVAL
1. Disconnect the ground cable from battery.
2. Disconnect the connector (A) from tumble generator valve assembly, and remove the tumble generator valve actuator.
• RH side
• LH side
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve ActuatorINSPECTION1. Check that the tumble generator valve actuator has no deformation, cracks or other damages.2. Check tumble generato ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Tumble Generator Valve ActuatorINSTALLATIONInstall in the reverse order of removal.NOTE:Use a new gasket.Tightening torque:6 N·m (0.6 kgf-m, 4.4 ft-lb) ...
Other materials:
Floor mat (if equipped)
CAUTION
If the floor mat slips forward and
interferes with the movement of the
pedals during driving, it could cause
an accident. Observe the following
precautions to prevent the floor mat
from slipping forward.
Be sure to use a genuine
SUBARU floor mat or an equivalent
designed wi ...
Dtc b2a10 battery voltage high
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A10 BATTERY VOLTAGE HIGHDiagnosis start condition:When ignition switch is ON.DTC detecting condition:DCM battery power supply input of 16 V or more continues for 5 seconds.Trouble symptom:RED LED illumi ...
Read diagnostic trouble code (dtc) Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATIONRead out DTCs stored in the airbag system and the occupant detection system.1. AIRBAG SYSTEM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information ...
