Subaru Crosstrek Service Manual: Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle Body
REMOVAL
1. Disconnect the ground cable from battery.
2. Lift up the vehicle.
3. Remove the under cover. Front Under Cover > REMOVAL">
4. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. Engine Coolant > REPLACEMENT">
5. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.
6. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the air intake boot aside so that it does not interfere with the work.
7. Disconnect the connectors (A) from the throttle position sensor.
8. Disconnect the preheater hose (B) from the throttle body.
9. Remove the throttle body from the intake manifold.
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyINSPECTION1. THROTTLE SENSOR (METHOD WITH CIRCUIT TESTER)1. Remove the glove box. Glove Box > REMOVAL">2. Turn the ignition switch to ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Throttle BodyINSTALLATIONInstall in the reverse order of removal.NOTE:Use a new gasket.Tightening torque:8 N·m (0.8 kgf-m, 5.9 ft-lb) ...
Other materials:
Dtc p0890 tcm power relay sense circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0890 TCM POWER RELAY SENSE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed.CAUTION:• After diagnosis, perform Clear Memory Mo ...
Removal
CONTROL SYSTEMS > Select LeverREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.3. Lift up the vehicle.4. Remove the center exhaust pipe. Cen ...
Dtc b1901 open in front p/t rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1901 OPEN IN FRONT P/T RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (RH) circuit is open.• Pretensioner (RH) is faulty.• Pretensioner harness (RH ...
