FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Rear Oxygen Sensor
REMOVAL
1. Disconnect the ground cable from battery.
2. Lift up the vehicle.
3. Remove the under cover. Front Under Cover > REMOVAL">
4. Disconnect the rear oxygen sensor connector.
(A) | Front oxygen (A/F) sensor connector | (B) | Rear oxygen sensor connector | (C) | Clip |
5. Apply spray-type lubricant to the threaded portion of rear oxygen sensor, and leave it for one minute or more.
6. Remove the rear oxygen sensor.
CAUTION:
When removing the rear oxygen sensor, wait until exhaust pipe cools, otherwise it will damage the exhaust pipe.
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel TankINSTALLATION1. Support the fuel tank with a transmission jack, set the fuel tank in place, and temporarily tighten the bolts of the fuel tank band.WARNING:A helper is required to perform this work.2. Tighten the bolts of the fuel tank band in the ord ...
Power steering
Power steering warning light
Type A
Type B
Power steering system features
The vehicle is equipped with an electric
power steering system. When the ignition
switch is turned to the "ON" position, the
power steering warning light on the
combination meter illuminates to inform
the driver t ...
Dtc c2022 tire 2 air pressure low (normal mode)
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2022 TIRE 2 AIR PRESSURE LOW (NORMAL MODE)NOTE:Refer to DTC C2024 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2024 TIRE 4 AIR PRESSURE LOW ( ...