Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control Solenoid

REMOVAL

CAUTION:

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.

1. INTAKE SIDE

1. Disconnect the ground cable from battery.

2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">

3. Remove the reservoir tank. (LH side only) Reservoir Tank > REMOVAL">

4. Disconnect the connector (A) from the oil control solenoid, and remove the oil control solenoid from the chain cover.

RH side

LH side

2. EXHAUST SIDE

1. Disconnect the ground cable from battery.

2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">

3. Remove the reservoir tank. (LH side only) Reservoir Tank > REMOVAL">

4. Disconnect the connector (A) from the oil control solenoid, and remove the oil control solenoid from the chain cover.

RH side

LH side

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSPECTION1. Check that the oil control solenoid has no deformation, cracks or other damages.2. Measure the resistance between the oil cont ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSTALLATIONInstall in the reverse order of removal.NOTE:• Use new O-rings.• Apply engine oil to O-ring.Tightening torque:6.4 N ...

Other materials:

Replacement
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)REPLACEMENT1. ONLY FOR MODELS WITHOUT EyeSightCAUTION:• Because the pressure sensor built into the H/U is easily damaged by static electricity, start the operation after performing static electrici ...

Tilt/telescopic steering wheel
WARNING Do not adjust the steering wheel tilt/telescopic position while driving. This may cause loss of vehicle control and result in personal injury. If the lever cannot be raised to the fixed position, adjust the steering wheel again. It is dangerous to drive without locking ...

Installation
MECHANICAL(H4DO) > Timing Chain AssemblyINSTALLATION1. TIMING CHAIN LHNOTE:• Be careful that the foreign matter is not into or onto the assembled component during installation.• Apply engine oil to all component parts of the timing chain.1. Prepare to attach the chain tensioner LH.(1) ...

© 2016-2024 Copyright www.sucross.com