FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Mass Air Flow and Intake Air Temperature Sensor
REMOVAL
1. Disconnect the ground cable from battery.
2. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the mass air flow and intake air temperature sensor.
Tilt/telescopic steering wheel
WARNING
Do not adjust the steering wheel
tilt/telescopic position while driving.
This may cause loss of
vehicle control and result in
personal injury.
If the lever cannot be raised to
the fixed position, adjust the
steering wheel again. It is dangerous
to drive without locking
...
Wiring diagram
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAM(1)Battery(5)Engine control module (ECM)(9)Torque sensor (main & sub)(2)Ignition switch(6)Power steering control module(10)CAN communication(3)STEERING warning light (combination meter)(7)Motor(11)VD ...
Inspection
LIGHTING SYSTEM > Rear Combination Light AssemblyINSPECTION1. Apply battery voltage between the connector terminals to check the lighting condition of the light.Terminal No.Inspection conditionsSpecification6 (+) — 3 (−)Apply battery voltage.Stop light on2 (+) — 3 (−)Tail (small) ...