FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock Sensor
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.
3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the air intake boot aside so that it does not interfere with the work.
4. Disconnect the connector (A) from the knock sensor, and remove the knock sensor from the cylinder block.
Removal
EXTERIOR/INTERIOR TRIM > Rear BumperREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...
Sliding moonroof
Open
Close
To open:
Press and hold the rear side of the
"OPEN/CLOSE" switch. The sun shade
will also be opened together with the
moonroof. The moonroof will stop at a
position approximately 1.6 in (4 cm) away
from the fully opened position. Press and
hold the rear side of the swit ...
SRS side airbag and SRS curtain airbag
The SRS side airbag is stored in the door
side of each front seat seatback, which
bears an "SRS AIRBAG" label.
In a moderate to severe side impact
collision, the SRS side airbag on the
impacted side of the vehicle deploys
between the occupant and the door panel
and supplements the seatbel ...