Subaru Crosstrek Service Manual: Removal

1. Release the fuel pressure. Fuel > PROCEDURE">

2. Disconnect the ground cable from battery.

3. Open the fuel filler lid and remove the fuel filler cap.

NOTE:

This operation is required to release the inner pressure of the fuel tank.

4. When removing the RH side, also perform the following steps.

(1) Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.

(2) Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the air intake boot aside so that it does not interfere with the work.

(3) Disconnect the connector from the mass air flow and intake air temperature sensor, and remove the clip (A) securing the bulkhead wiring harness.

(4) Remove the air cleaner case (rear) together with the air cleaner element.

5. Remove the intake manifold protector.

• RH side

• LH side

6. Disconnect the connectors (A) from fuel injector.

7. Disconnect the quick connector (B) of the fuel delivery pipe from the fuel pipe.

CAUTION:

• Be careful not to spill fuel.

• Catch the fuel from the pipes using a container or cloth.

Disconnect the quick connector as shown in the figure.

8. Remove the bolts which hold fuel pipe onto the cam carrier, and remove the fuel pipe together with the fuel injector.

9. Remove the fuel injector from the fuel pipe.

(1) Remove the fuel injector holder from one side of flange section (A) of the fuel pipe.

(2) While holding one side of fuel injector holder (B) you removed in step (1) by finger, remove the other side of fuel injector holder from the flange section (C) of the fuel pipe.

(3) Remove the fuel injector holder from the fuel pipe and fuel injector, and remove the fuel injector from the fuel pipe.

(4) Remove the fuel injector on the LH side in the same manner.

Inspection

Installation

Other materials:

Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Converter CaseASSEMBLY1. Install the oil drain plug.Tightening torque:70 N·m (7.1 kgf-m, 51.6 ft-lb)2. Install the overflow drain plug.NOTE:Overflow plug of differential gear oil is temporarily attached.3. Install all plugs.NOTE:Use new O-rings.T ...

Dtc u0100 lost communication with ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedures. Basic Diagnostic Procedure">1. OUTLINE OF DIA ...

Initial illumination for system check
Several of the warning and indicator lights illuminate when the ignition switch is initially turned to the "ON" position. This permits checking the operation of the bulbs. Apply the parking brake and turn the ignition switch to the "ON" position. For the system check, the following lights ...