Subaru Crosstrek Service Manual: Removal

WARNING:

Place “NO OPEN FLAMES” signs near the working area.

• Be careful not to spill fuel.

• If the fuel gauge indicates that two thirds or more of the fuel is remaining, be sure to drain fuel before starting work to avoid the fuel to spill.

• Be careful not to drop or apply any impact to the fuel pump during work. This may deteriorate its performance.

The fuel filter is built in fuel pump assembly.

1. Remove the fuel pump assembly. Fuel Pump > REMOVAL">

2. Remove the fuel level sensor. Fuel Level Sensor > REMOVAL">

3. Remove the connector cable from the clip, and disconnect the connector (A) of the connector cable.

4. Push the fuel filter assembly in the direction of the arrow to compress, and detach the connecting clip.

5. Release the claw using a flat tip screwdriver or similar tool wrapped with a protection tape, and remove the tube assembly from the fuel chamber assembly.

6. Release three claws on the fuel pump holder from the fuel chamber assembly, and raise the fuel filter assembly.

7. Using a flat tip screwdriver or similar tool wrapped with a protection tape, remove the tube assembly from the fuel chamber assembly, and separate the fuel filter assembly and fuel chamber assembly.

8. Using a precision driver or similar tool wrapped with a protection tape, expand the claws on the fuel pump.

9. Release the claws on the fuel pump.

10. Using a flat tip screwdriver or similar tool wrapped with a protection tape, press on the fuel pump and remove the fuel pump together with the fuel pump holder from the fuel filter assembly.

CAUTION:

If O-rings remain on the fuel filter assembly side, carefully remove them with a precision screwdriver or similar tool wrapped with a protection tape.

11. Remove the spacer (A) and connector cable (B) from the fuel pump.

12. Remove the pressure regulator from the fuel filter assembly.

13. Remove O-ring (A), O-ring (B), and backup ring (C) from the pressure regulator.

Installation

Fuel injector

Other materials:

Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...

Dtc b2285 steering lock position signal correlation
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2285 STEERING LOCK POSITION SIGNAL CORRELATIONDTC detecting condition:When the steering lock position signal transmitted from the steering lock CM via solid line and the steeri ...

Inspection
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemINSPECTIONSymptomsRepair orderWiper and washers do not operate.(1) Wiper fuse (F/B No. 14, 15)(2) Combination switch(3) Motor assembly - wiper(4) Wiring harnessWipers do not operate in LO or HI.(1) Combination switch(2) Motor assembly - wiper(3) W ...