Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filler Pipe

REMOVAL

WARNING:

Place “NO OPEN FLAMES” signs near the working area.

CAUTION:

Be careful not to spill fuel.

1. Release the fuel pressure. Fuel > PROCEDURE">

2. Drain fuel. Fuel > PROCEDURE">

3. Disconnect the ground cable from battery.

4. Open the fuel filler lid and remove the fuel filler cap.

5. Turn the fuel filler pipe protector in the direction of the arrow to unlock and remove it.

6. Remove the rear sub frame assembly. Rear Sub Frame > REMOVAL">

7. Remove the rear mud guard RH. Mud Guard > REMOVAL">

8. Disconnect the fuel filler hose (A) and evaporation hose (B) from the fuel filler pipe assembly.

9. Remove the bolts and nuts which secure the fuel filler pipe assembly to the vehicle.

10. Remove the fuel filler pipe assembly from the underside of the vehicle.

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filler PipeINSPECTION1. Check that the fuel filler pipe assembly has no deformation, cracks or other damages.2. Check that the fuel hose has no cracks, da ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filler PipeINSTALLATION1. Open the fuel filler lid.2. Insert the fuel filler pipe assembly into the rubber saucer from inside of the rear fender.3. Instal ...

Other materials:

Dtc b16f6 curtain airbag sensor rh recognition error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F6 CURTAIN AIRBAG SENSOR RH RECOGNITION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Curtain airbag sensor RH is misinstalled.• Airbag CM is faulty.CAUTION:Before perfor ...

Dtc c1361 normal closing valve 1
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1361 NORMAL CLOSING VALVE 1NOTE:For the diagnostic procedure, refer to “DTC C1362 NORMAL CLOSING VALVE 2”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1362 ...

Engine lubrication system trouble in general Inspection
LUBRICATION(H4DO) > Engine Lubrication System Trouble in GeneralINSPECTIONBefore performing diagnostics, make sure that the engine oil level is correct and no oil leakage exists.TroublePossible causeCorrective actionWarning light remains ON.a. Oil pressure switch failure Cracked diaphragm or ...

© 2016-2024 Copyright www.sucross.com