Subaru Crosstrek Service Manual: Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature Sensor
REMOVAL
1. Disconnect the ground cable from battery.
2. Drain engine coolant. Engine Coolant > REPLACEMENT">
3. Disconnect the connector (A) from the engine coolant temperature sensor, and remove the engine coolant temperature sensor.
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature SensorINSPECTION1. Check that the engine coolant temperature sensor has no deformation, cracks or other damages.2. Immerse the engin ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Coolant Temperature SensorINSTALLATIONInstall in the reverse order of removal.NOTE:Use a new gasket.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft- ...
Other materials:
Dtc p0451 evap system (cpc) pressure sensor/switch circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0451 EVAP SYSTEM (CPC) PRESSURE SENSOR/SWITCH CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, ...
Antenna cord Location
WIRING SYSTEM > Antenna CordLOCATION1. WITHOUT TELEMATICSConnectorConnecting toNo.PoleColorAreaNo.DescriptionAN13B-2 Audio3B-2 Navigation unitAN21B-2 Audio1B-2 Navigation unitAN31B-2AN4Antenna cordAN41B-2AN3AN51B-1AN6AN61B-1AN5AN73C-3AN9AN93C-4AN7AN101C-4R97AN113B-4AN15AntennaAN153B-4AN11Antenna ...
Removal
MECHANICAL(H4DO) > Rocker CoverREMOVAL1. ROCKER COVER RHNOTE:When replacing a single part, perform the work with the engine assembly installed to body.1. When working on the vehicleNOTE:When working on the vehicle, perform the following steps also.(1) Remove the air cleaner case. Air Cleaner Cas ...
