FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position Sensor
REMOVAL
1. INTAKE SIDE
1. Disconnect the ground cable from battery.
2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">
3. Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor from the chain cover.
• RH side
• LH side
2. EXHAUST SIDE
1. Disconnect the ground cable from battery.
2. Remove the under cover. Front Under Cover > REMOVAL">
3. Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor from the chain cover.
• RH side
• LH side
Dtc p0455 evap system (cpc) leak detected (large leak)
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0455 EVAP SYSTEM (CPC) LEAK DETECTED (LARGE LEAK)DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Fuel odor• There is a hole of more than 1.0 ...
Installation
AIRBAG SYSTEM > Front Sub SensorINSTALLATIONCAUTION:• If the airbag has been activated, replace the front sub sensor with a new part.• Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.• When installing the sensor, insert the set pin on the backs ...
Electrical component location Location
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Steering gearbox(3)STEERING warning light(5)VDCCM&H/U(2)Power steering control module(4)Engine control module (ECM)(6)Data link connector (for Subaru Select Monitor)• U5 and U6 models• C ...