FRONT SUSPENSION > Front Ball Joint
REMOVAL
1. Lift up the vehicle, and then remove the front wheels.
2. Remove the under cover - front. Front Under Cover > REMOVAL">
3. Remove the clamp - stabilizer bushing on the left and right sides.
4. Remove the ball joint assembly.
(1) Pull out the cotter pin (a), and remove the castle nut (b).
(2) Lower the front arm assembly, and remove the ball stud.
(3) Remove the bolt from the housing assembly - front axle.
(4) Extract the ball joint assembly from the housing assembly - front axle.
Operation
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence ControlOPERATION1. While the ABS sequence control is being performed, the operation of the hydraulic unit can be checked using the brake tester or pressure gauge after the hydraulic unit solenoid valve operation.2. ABS sequence control can be started ...
Dtc c0046 body integrated module communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0046 BODY INTEGRATED MODULE COMMUNICATION CIRCUITDTC detecting condition:No CAN signal received from body integrated unit.Trouble symptom:• VDC may not operate.• Hill start assis ...
Removal
SECURITY AND LOCKS > Access BuzzerREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the clips and screws, and turn over the front side of the mud guard - front RH.4. Remove the access buzzer.(1) Disconnect the connector.(2) Remove the clip and det ...