Subaru Crosstrek Service Manual: Removal

CAUTION:

• When the stereo camera or windshield glass has been replaced, removed or installed, always perform the adjustment and inspection of the camera. (When the stereo camera has been replaced with a new part, the camera remains in a failed state until adjustment and inspection are performed.)

• Since the stereo camera is a precision equipment, install the protective cover before handling it. (New stereo camera is equipped with a protective cover as a service part.)

• During removal, do not hold at the left and right cameras.

• Do not apply any impact to the stereo camera. (Even the slightest shock will deviate the optical axis of the camera, resulting in the loss of normal operation of the camera.)

• Do not disassemble the stereo camera.

• Attach the protective cover to the replacement part, put it into the box in the same way as the other parts and return it. Cover the replaced stereo camera with a protective cover.

• Do not touch the lens filter on the stereo camera. If touched, replace the stereo camera.

• When removing the stereo camera cover assembly, cover with dust-free paper such as copy paper to avoid interference with the lens filter section, and attach the paper using tape while being careful not to let the adhesive surface contact the glass surface. Be sure to remove the paper after the procedure.

Also, do not put your hand on the polyurethane section of the windshield contact surface. Doing so may cause the polyurethane section to be removed, which may interfere with the normal operation if it hangs down in front of the lens filter section.

1. Disconnect the ground cable from battery. NOTE">

2. Attach dust-free paper (a) such as copy paper to the stereo camera cover assembly.

3. Remove the stereo camera cover assembly.

(1) Disconnect the claws and hooks and remove the cap.

(2) Remove the bolt.

(3) Pull down the rear of the stereo camera cover assembly, and then release the clips.

(4) Release the hook on the front side of stereo camera cover assembly.

(5) Disconnect the connectors, and remove the stereo camera cover assembly.

4. Remove the stereo camera.

(1) Disconnect the connector.

(2) Remove the nuts, and then remove the stereo camera.

Remove the camera plate (a) as required.

Installation

Switches and harness

Other materials:

Dtc p1492 coil 1 egr "a" control circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1492 COIL 1 EGR "A" CONTROL CIRCUIT LOWNOTE:For the diagnostic procedure, refer to DTC P1498. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P1498 COIL 4 EGR "A" CONTROL ...

Removal
SECURITY AND LOCKS > Steering Lock CMREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do not allow harness and connectors to i ...

Maintenance precautions
When maintenance and service are required, it is recommended that all work be done by an authorized SUBARU dealer. If you perform maintenance and service by yourself, you should familiarize yourself with the information provided in this section on general maintenance and service for your SU ...