Subaru Crosstrek Service Manual: Removal
EXTERIOR/INTERIOR TRIM > Side Garnish
REMOVAL
1. Remove the clips and detach the side garnish assembly.
(1) | Garnish ASSY - fender | (2) | Garnish ASSY - rear quarter | (3) | Garnish ASSY - side sill |
2. Remove the garnish assembly or protector on the fender panel.
CAUTION:
Do not reuse the garnish assembly and protector that have been deformed during removal.
(1) Attach the protective tape to the periphery of the garnish and protector.
(2) Heat the garnish and protector sections for 3 — 5 minutes at 40 — 60°C using a heat light or a drier.
CAUTION:
Be careful not to burn yourself.
(3) Separate the bonded part of double sided tape with a nylon cord or equivalent.
(4) Release the clips, and remove the garnish assembly and protector.
Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Ins ...
Sun visor
...
Other materials:
Disposal
REAR SUSPENSION > Rear Shock AbsorberDISPOSALCAUTION:• Before discarding the strut COMPL and the shock absorber COMPL, be sure to wear goggles to protect eyes from gas, oil and cutting powder.• Do not disassemble the strut COMPL and the shock absorber COMPL or throw them into flames.& ...
General diagnostic table Inspection
BRAKE > General Diagnostic TableINSPECTION Trouble and possible causeCorrective action1. Insufficient braking(1) Fluid leakage from the hydraulic mechanismRepair or replace. (cup, piston seal, piston boot, master cylinder piston kit, pipe or hose)(2) Entry of air into the hydraulic mechanismBleed ...
Dtc b14e6 mode door actuator stepping motor circuit short-circuit
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E6 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT SHORT-CIRCUITDTC detecting condition:Mode door actuator stepping motor circuit is shorted.Trouble symptom:Vent does not change.Wiring diagram:Air condi ...
