Subaru Crosstrek Service Manual: Removal

1. CROSSTREK MODEL

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the screws and clips, and remove the trim panel - rear quarter pillar UPR.

3. Remove the rear seat cushion assembly. Rear Seat > REMOVAL">

4. Release the clips and claws, and then remove the cover side sill - rear INN.

CAUTION:

Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN.

5. Remove the mat - rear floor CTR and the spacer - rear floor side.

6. Remove the clips, and remove the trim panel - rear skirt.

7. Remove the trim panel - rear apron.

(1) Remove the caps, and remove the bolts.

(2) Remove the screws.

(3) Disengage the clips, and remove the trim panel - rear apron.

NOTE:

For LH side, disconnect the connector of the luggage room light.

Installation

Roof molding

Other materials:

Installation
EXTERIOR/INTERIOR TRIM > Roof TrimINSTALLATIONCAUTION:• For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION ...

Dtc b1823 short in side airbag rh (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1823 SHORT IN SIDE AIRBAG RH (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Side airbag harness (RH) is shorted to power supply.• Side airbag module (RH) is faulty.• ...

Dtc p0517 battery temperature sensor circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0517 BATTERY TEMPERATURE SENSOR CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATI ...