EXTERIOR/INTERIOR TRIM > Rear Gate Garnish
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">
3. Remove the arm assembly - rear wiper.
(1) Remove the cover - rear wiper arm.
(2) Remove the nut, and remove the arm assembly - rear wiper.
4. Remove the motor assembly - rear wiper.
(1) Disconnect the harness connector of the motor assembly - rear wiper.
(2) Remove the bolts, and remove the motor assembly - rear wiper.
5. Remove the garnish assembly - rear gate.
(1) Disconnect the harness connector of license plate light assembly.
(2) Remove the nuts.
(3) Remove the clips and remove the garnish assembly - rear gate.
Dtc p0014 "b" camshaft position - timing over-advanced or system performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0014 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...
By Dialpad
Input the phone number manually using
the keypad displayed on the screen.
Phone (Dialpad) screen
Allow you to enter numbers from 0 to
9 and *, #, and +. To enter "+", press
and hold the "0" key.
Delete one character from the entered
characters.
Switch the screen to the phone
(m ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Manifold Absolute Pressure SensorREMOVAL1. Disconnect the ground cable from battery.2. Disconnect the connector (A) from the manifold absolute pressure sensor, and remove the manifold absolute pressure sensor from intake manifold. ...