Subaru Crosstrek Service Manual: Removal
EXTERIOR/INTERIOR TRIM > Rear Bumper
REMOVAL
1. CROSSTREK MODEL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the light assembly - rear combination.
CAUTION:
Be careful not to damage the clips.
(1) Release the bolts and clips, then pull out the light assembly - rear combination to the vehicle rear.
(2) Disconnect the connector and remove the light assembly - rear combination.
3. Remove the bumper face - rear.
(1) Remove the clips inside the wheel housing.
(2) Remove the clips at the lower side of the bumper face - rear.
(3) Detach (b) and (c) while pulling up (a) of the bumper face - rear.
(4) Detach (e) while pulling up (d) of the bumper face - rear.
(5) Detach the opposite side in the same manner.
(6) Detach in order from (f) to (h) while pulling up the center part of the bumper face - rear.
CAUTION:
Do not pull forcibly. It may damage the flange section on the bumper face - rear side when it comes off from the claws of the bracket - rear bumper.
4. Remove the bolts and nuts, and remove the bumper beam COMPL - rear.
NOTE:
After all nuts are removed, raise the bumper beam COMPL - rear a little to remove it from vehicle body.
5. Remove bumper brackets.
(1) Remove the screws.
(2) Turn over the trim panel - rear apron, and detach the claw of the clip from the back side.
(3) Remove the clip, and remove the bracket - rear bumper lower.
6. From behind the bumper, release the claws, and remove the reflex reflector assembly.
Repair
EXTERIOR/INTERIOR TRIM > Rear BumperREPAIRRefer to the description concerning repair in “Front Bumper” section. Front Bumper > REPAIR"> ...
Other materials:
Drive cycle Procedure
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Drive CyclePROCEDUREIt is possible to complete diagnosis of the DTC by performing the indicated drive cycle. After the repair for the DTC, perform a necessary drive cycle and make sure the function recovers and the DTC is recorded.1. PREPARATION ...
Electrical component location Location
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Engine control module (ECM)(4)Cruise indicator light and cruise set indicator light(7)Neutral position switch (MT model)(2)Cruise control command switch(5)Transmission control module (TCM) (CVT model)(8)Clutch switch (M ...
Preparation tool
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, re ...
