EXTERIOR/INTERIOR TRIM > Glove Box
REMOVAL
NOTE:
Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">
1. Remove the pocket assembly.
(1) Attach the protective tape (a) to the panel center LWR.
(2) Remove the damper COMPL - pocket.
(3) Release the stoppers and remove the pocket assembly by pulling it toward you.
2. Remove the back panel - pocket.
(1) Release the clips, and remove the under cover assembly - passenger.
(2) Remove the clips, and remove the cover - instrument panel side RH.
NOTE:
Remove the cover - instrument panel side RH by using a plastic remover.
(3) Release the clips, and remove the ornament - panel assembly passenger.
NOTE:
To facilitate the removal, push the clip of the ornament - panel assembly passenger from the backside.
(4) Remove the glove box light LED, and disconnect the connector.
(5) Remove the screws, claws and harness clamp, then remove the back panel - pocket.
Inspection
COOLING(H4DO) > RadiatorINSPECTION1. Check that the radiator does not have deformation, cracks or damage.2. Check that the hose has no cracks, damage or loose part.3. Remove the radiator cap, fill the radiator with engine coolant, and then install the radiator cap tester to the filler neck of rad ...
Front seatbelts
1. Adjust the seat position according to
the following procedure.
Driver's seat: Adjust the seatback to the
upright position. Move the seat as far from
the steering wheel as practical while still
maintaining full vehicle control.
Front passenger's seat: Adjust the seatback
to the upright ...
Dtc p0171 system too lean bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0171 SYSTEM TOO LEAN BANK 1Refer to DTC P0172 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0172 SYSTEM TOO RICH BANK 1">1. OUTLINE OF DIAGNOSISDetect fu ...