EXTERIOR/INTERIOR TRIM > Door Trim
REMOVAL
1. FRONT DOOR
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - front door.
(1) Attach the protective tape (a).
(2) Open the cover and remove the screw.
(3) Remove the clips, and remove the trim panel - front door from the panel assembly - front door.
NOTE:
It is easier to remove the door trim if the removal is performed from the gray arrow section.
(4) Detach the door lock cable (a) and door open cable (b) from the remote assembly - door.
(5) Disconnect the harness connector and remove the trim panel - front door.
3. Remove each part as required.
• Remote assembly - door: Front Inner Remote > REMOVAL">
• Switch - power window main: Power Window Control Switch > REMOVAL">
• Weather strip - door INN: Door Trim > DISASSEMBLY">
2. REAR DOOR
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear door.
(1) Attach the protective tape (a).
(2) Open the cover and remove the screw.
(3) Remove the clips, and remove the trim panel - rear door from the panel assembly - rear door.
NOTE:
It is easier to remove the door trim if the removal is performed from the gray arrow section.
(4) Detach the door lock cable (a) and door open cable (b) from the remote assembly - door.
(5) Disconnect the harness connector and remove the trim panel - rear door.
3. Remove each part as required.
• Remote assembly - door: Rear Inner Remote > REMOVAL">
• Switch - power window sub: Power Window Control Switch > REMOVAL">
• Weather strip - door INN: Door Trim > DISASSEMBLY">
Anti-entrapment function
CAUTION
Never attempt to test this function
using fingers, hands or other
parts of your body.
The anti-entrapment function
may not operate properly if some
object gets trapped just before
the window fully closes.
NOTE
If a window detects an impact similar
to that caused by t ...
Keyless buzzer volume setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the button.
3. Select a volume level by operating the
" " or "
" switch, and confirm the set ...
Inspection
DRIVE SHAFT SYSTEM > Front Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. If faulty, repair or replace.• PTJ (pillow tripod joint)Check for seizure, corrosion, damage, wear and excessive play.• EBJ (high-efficiency compact ball fixed joint)Check for seiz ...