Subaru Crosstrek Service Manual: Removal

1. Disconnect the ground cable from battery. NOTE">

NOTE:

On CVT models, shift the select lever into “N” before disconnecting the battery ground cable.

2. Remove the console box assembly.

(1) Release the claws, and then remove the boot - hand brake.

(2) Move the seat forward, and remove the bolts after detaching the left and right caps.

(3) Remove the screws and clips, disconnect the harness connector and remove the console box assembly.

3. Remove the cover - shift lever.

(1) Remove the shift knob. (MT model)

(2) Release the clips and claws, then pull up the cover - shift lever.

4. Remove the left and right panel center LWR.

(1) Remove the screws and clips.

(2) Release the claws, and then pull the panel center LWR to remove.

Installation

Cowl panel

Other materials:

Installation
EXTERIOR/INTERIOR TRIM > Roof TrimINSTALLATIONCAUTION:• For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the “EyeSight” section and observe the precautions for installation. Stereo Camera > INSTALLATION ...

Installation
ENTERTAINMENT > Front Accessory Power Supply SocketINSTALLATIONCAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system components, always refer ...

Inspection
PARKING BRAKE > Parking Brake Assembly (Rear Disc Brake)INSPECTION1. Measure the inner diameter of the rear disc rotor. If scoring or worn is found on the disc, replace the rear disc rotor.Disc rotor inner diameter:Specification: 170 mm (6.69 in)Service limit: 171 mm (6.73 in)2. Measure the linin ...