EXTERIOR BODY PANELS > Rear Sealing Cover
REMOVAL
1. Disconnect the ground cable from battery. NOTE">
2. Remove the trim panel - rear door. Door Trim > REMOVAL">
3. Remove the sealing cover - rear door.
CAUTION:
• Carefully remove the butyl tape. Excessive force will easily break the cover.
• If the sealing cover - rear door gets broken, replace it with a new part.
• Be careful not to allow the butyl tape to contact any trims and seats because the butyl tape, which has a strong adhesive force, is difficult to remove once it adhered.
(1) Remove the screw to remove the bracket - door trim rear.
(2) Carefully remove the butyl tape to remove the sealing cover - rear door.
Removal
MECHANICAL(H4DO) > Engine AssemblyREMOVAL1. Open the front hood, and make alignment marks (A) on both the front hood and the front hood striker by using a marker pen.2. Remove the front hood striker from the front hood.3. Change the front hood stay position from (A) to (B), and completely open th ...
Birthday setting
1. Perform the preparation steps according
to "Preparation for date setting" 3-
56.
2. Operate the "
" or "
" switch to
select the "Birthday" item. Then push the
button.
3. Select an entry in the list to set by
operating the "
" or "
" switch. Then
push the
...
Component
WHEEL AND TIRE SYSTEM > General DescriptionCOMPONENT(1)Screw(4)TPMS & keyless entry control moduleTightening torque: N·m (kgf-m, ft-lb)(2)Transmitter (snap in type)(5)TPMS CMT1:1.4 (0.14, 1.0)(3)Valve T2:7.5 (0.76, 5.5) T3:13 (1.33, 9.6)(1)TPMS & keyless entry control module(2) ...