EXTERIOR BODY PANELS > Front Sealing Cover
REMOVAL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the sealing cover - front door.
CAUTION:
• Carefully remove the butyl tape. Excessive force will easily break the cover.
• If the sealing cover - front door gets broken, replace it with a new part.
• Be careful not to allow the butyl tape to contact any trims and seats because the butyl tape, which has a strong adhesive force, is difficult to remove once it adhered.
(1) Remove the screw to remove the bracket - door trim front.
(2) Carefully remove the butyl tape to remove the sealing cover - front door.
Component
SECURITY AND LOCKS > General DescriptionCOMPONENT1. DOOR LOCK ASSEMBLY(A)Front(B)Rear (1)Grommet - screw(9)Key lock - door (driver’s seat only)(17)Frame ASSY - rear door outer(2)Remote ASSY - door(10)Spacer - door handle outer B (3)Cap remote(11)Spacer - door handle outer ATightening ...
Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by han ...