Subaru Crosstrek Service Manual: Removal
EXTERIOR BODY PANELS > Front Door
REMOVAL
1. FRONT DOOR PANEL
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the trim panel - front door. Door Trim > REMOVAL">
3. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">
4. Remove the outer mirror assembly. Outer Mirror Assembly > REMOVAL">
5. Remove the front door speaker assembly. Front Speaker > REMOVAL">
6. Remove the cover B pillar - front door INN.
CAUTION:
• Always replace with a new part, because engagement of the claw weakens.
• Do not damage the sash while removing.
7. Remove the front door impact sensor assembly. Front Door Impact Sensor > REMOVAL">
8. Remove the glass assembly - front door and the glass - front door partition. Front Door Glass > REMOVAL">
9. Remove the regulator & motor assembly - front of the front door. Front Regulator and Motor Assembly > REMOVAL">
10. Remove the latch and actuator assembly - front. Front Door Latch and Door Lock Actuator Assembly > REMOVAL">
11. Remove the handle - door outer and the cover - handle front outer. Front Outer Handle > REMOVAL">
12. Remove the weather strip - front door.
CAUTION:
If the weather strip clip is removed with excessive force, the weather strip may be damaged. Be sure to use clip remover to remove.
13. Remove the bolts and nuts, and then detach the checker assembly - front door.
14. Remove the cover side sill - front INN and cover side sill - front. Lower Inner Trim > REMOVAL">
15. Disconnect the front door impact sensor harness connector. Airbag Connector > PROCEDURE">
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
16. Disconnect the front door harness connectors.
(1) Disconnect the connector of door harness from body harness.
(2) Push in the claws to remove the grommet, and pull out the door harness connector.
A | Driver’s side |
B | Passenger’s side |
17. Before removing the panel assembly - front door, make the following preparations.
(1) Put a wooden block on a floor jack and place the jack under the panel assembly - front door.
(2) Support the panel assembly - front door with the jack to protect it from damage.
CAUTION:
Do not excessively lift the panel assembly - front door with the floor jack. The door hinges may be damaged.
18. Remove the door-side bolts for the upper hinge - front door and the lower hinge - front door to remove the panel assembly - front door.
CAUTION:
The panel assembly - front door is heavy. When removing and installing it, always work in a team of two or more persons.
19. Remove the door hinge from vehicle.
2. FRONT DOOR HINGE
1. Remove the bolts from the vehicle side to disconnect the checker assembly - front door.
2. Before removing the door hinge, make the following preparations.
(1) Put a wooden block on a floor jack and place the jack under the panel assembly - front door.
(2) Support the panel assembly - front door with the jack to protect it from damage.
CAUTION:
Do not excessively lift the panel assembly - front door with the floor jack. The door hinges may be damaged.
3. Remove the bolts of the upper hinge - front door or the lower hinge - front door.
CAUTION:
Do not remove the upper hinge - front door and the lower hinge - front door at the same time.
4. Remove the hinge - front door from the vehicle.
Adjustment
EXTERIOR BODY PANELS > Front DoorADJUSTMENTAdjust the clearance around the panel assembly - front door as follows.PartStandardAFender COMPL - front to Panel assembly - front door4.5±1.0 mm (0.18± ...
Installation
EXTERIOR BODY PANELS > Front DoorINSTALLATION1. FRONT DOOR PANEL1. Put a wooden block on a jack and place the panel assembly - front door on it.2. Apply grease to the sliding area of door hinges, a ...
Other materials:
Assembly
EXHAUST(H4DO) > Front Exhaust PipeASSEMBLY1. Install each cover to the front exhaust pipe.Tightening torque:13 N·m (1.3 kgf-m, 9.6 ft-lb)(A)Front exhaust pipe upper cover(E)Front catalytic converter lower cover LH(H)Front exhaust pipe side cover LH (rear)(B)Front catalytic converter upper ...
Dtc b1572 imm circuit except antenna circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1572 IMM CIRCUIT EXCEPT ANTENNA CIRCUIT1. EXCEPT FOR C0 AND C5 MODELSDTC detecting condition:Communication error between keyless access CM and ECMTrouble symptom:Engine will no ...
Dtc p0346 camshaft position sensor "a" circuit range/performance bank 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0346 CAMSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCE BANK 2NOTE:For the diagnostic procedure, refer to DTC P0345. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0345 CAMSH ...
