Subaru Crosstrek Service Manual: Removal

1. FRONT DOOR

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the trim panel - front door. Door Trim > REMOVAL">

3. Remove the outer mirror assembly. Outer Mirror Assembly > REMOVAL">

4. Remove the sealing cover - front door. Front Sealing Cover > REMOVAL">

5. Remove the glass assembly - front door. Front Door Glass > REMOVAL">

6. Remove the running channel - front door.

7. Remove the weather strip outer - front door.

CAUTION:

• When removing the weather strip outer, be careful not to damage the vehicle.

• Do not reuse the weather strip outer. Always replace with a new part.

8. Peel the door sash tape from the door sash.

NOTE:

• If the tape is difficult to remove, warm the tape with a hairdryer, etc. to make the removal easier.

Use a household hairdryer. Do not use industrial dryers.

• If tape residue is remaining on the door sash, wipe clean.

1. Disconnect the ground cable from battery. NOTE">

2. Remove the trim panel - rear door. Door Trim > REMOVAL">

3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">

4. Remove the glass assembly - rear door. Rear Door Glass > REMOVAL">

5. Remove the running channel - rear door.

6. Remove the weather strip outer - rear door.

CAUTION:

• When removing the weather strip outer, be careful not to damage the vehicle.

• Do not reuse the weather strip outer. Always replace with a new part.

7. Peel the door sash tape from the door sash.

NOTE:

• If the tape is difficult to remove, warm the tape with a hairdryer, etc. to make the removal easier.

Use a household hairdryer. Do not use industrial dryers.

• If tape residue is remaining on the door sash, wipe clean.

Installation

Front door

Other materials:

Inspection
WHEEL AND TIRE SYSTEM > Tire and WheelINSPECTION1. TIRECAUTION:When replacing a tire, make sure to use tires of the same size, construction and load range as originally installed.1. Tire size and tire inflation pressure check General Description > SPECIFICATION">2. Cracks, damage and ...

Removal
CLUTCH SYSTEM > Release Bearing and LeverREMOVAL1. Remove the transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the two clips from the release lever and remove the release bearing.CAUTION:Be careful not to deform the clips.3. Remove the dust cove ...

Dtc c1731 g sensor abnormal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1731 G SENSOR ABNORMALNOTE:For the diagnostic procedure, refer to “DTC C1732 LATERAL G SENSOR”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1732 LATERAL G ...