EXHAUST(H4DO) > Muffler
REMOVAL
CAUTION:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
1. Turn the ignition switch to OFF.
2. Lift up the vehicle.
3. Remove the bolts and self-locking nuts which secure the rear exhaust pipe to the muffler.
4. Apply a coat of spray type lubricant to the mating area of cushion rubber.
5. Remove the muffler from the cushion rubber.
CAUTION:
Be careful not to drop the muffler during removal.
6. Remove the heat shield cover from the vehicle.
Welcome screen
When the door is unlocked and the
driver's door is opened, the welcome
screen will appear for a short time.
NOTE
The welcome screen will disappear
when the ignition switch is turned to
the "ON" position while the welcome
screen is displayed.
If any of the doors (including the
re ...
Adjustment
VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)ADJUSTMENT1. VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight)After installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle se ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearINSTALLATION1. Install the taper roller bearing (transfer case side) outer race.(A)Taper roller bearing (transfer case side) outer race(B)Transfer case2. Apply a coat of grease to the taper roller bearing (transfer case side) of tran ...