Subaru Crosstrek Service Manual: Removal

CAUTION:

Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.

1. Disconnect the ground cable from battery. NOTE">

2. Lift up the vehicle.

3. Remove the under cover. Front Under Cover > REMOVAL">

4. Disconnect the front oxygen (A/F) sensor connector (A) and rear oxygen sensor connector (B) and remove the clip (C) fastening the harness.

5. Remove the bolts, springs, and nuts securing the rear exhaust pipe to the center exhaust pipe.

6. Remove the bolt which holds center exhaust pipe to hanger bracket.

7. Remove the front exhaust pipe and center exhaust pipe from vehicle as a unit.

CAUTION:

• The front exhaust pipe and center exhaust pipe are very heavy. Be careful not to drop the exhaust pipes when removing.

• After removing the front exhaust pipe and center exhaust pipe, do not apply excessive pulling force on the rear exhaust pipe.

Assembly

Disassembly

Other materials:

Dtc b11f7 side impact deployment
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B11F7 SIDE IMPACT DEPLOYMENTDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:This DTC is displayed when the side airbag module and curtain airbag module are deployed.Once this DTC is displayed, t ...

Dtc p2122 throttle/pedal position sensor/switch "d" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2122 THROTTLE/PEDAL POSITION SENSOR/SWITCH "D" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After ...

Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...