Subaru Crosstrek Service Manual: Removal
ENTERTAINMENT > Data Communication Module
REMOVAL
1. DATA COMMUNICATION MODULE
CAUTION:
Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">
3. Remove the glove box. Glove Box > REMOVAL">
4. Remove the center grille assembly. Air Vent Grille > REMOVAL">
5. Remove the audio assembly or navigation assembly. Audio > REMOVAL">
6. Remove the data communication module.
(1) Remove the screws.
(2) Remove the audio bracket or navigation bracket, and then remove the data communication module.
CAUTION:
Do not drop or apply any impact to the data communication module.
2. BACKUP BATTERY
CAUTION:
Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the data communication module. Data Communication Module > REMOVAL">
3. Remove the backup battery.
(1) Remove the screws, and then remove the battery cover.
Preparation tool:
TORX® T10
(2) Disconnect the connector and remove the backup battery.
Inspection
ENTERTAINMENT > Data Communication ModuleINSPECTION1. BACKUP BATTERY1. Measure the voltage between connector terminals.Preparation tool:Circuit testerTerminal No.Standard1 (+) — 2 (−)2 V or ...
Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille ass ...
Other materials:
Cvt control system Wiring diagram
WIRING SYSTEM > CVT Control SystemWIRING DIAGRAM ...
Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...
