Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

3. Remove the glove box. Glove Box > REMOVAL">

4. Remove the center grille assembly. Air Vent Grille > REMOVAL">

5. Remove the audio assembly.

(1) On manual A/C models, disconnect the control cables from both sides of the heater & cooling unit.

(2) Attach the protective tape (a) to the cover - shift lever.

(3) Remove the bolts, release the claws, and partially pull out the audio assembly.

NOTE:

• Release the claw by using a clip remover wrapped with protective tape.

• If the antenna cable interferes with the removal operation of the side attachment bolts (for model with telematics), move the antenna cable aside before service as necessary.

(4) Disconnect the connectors, and remove the audio assembly.

6. Remove the screws, and then remove the audio bracket.

• The model with telematics is equipped with the data communication module under the audio assembly.

• When sending the audio for repair, remove the audio bracket and heater control assembly, and install on the vehicle as shown in the figure below. Control Panel > REMOVAL">

Installation

Audio system

Other materials:

Fuel pressure Inspection
MECHANICAL(H4DO) > Fuel PressureINSPECTION1. Release the fuel pressure. Fuel > PROCEDURE">2. Open the fuel filler lid and remove the fuel filler cap.NOTE:This operation is required to release the inner pressure of the fuel tank.3. Disconnect the fuel delivery tube from the fuel delive ...

Removal
LIGHTING SYSTEM > Turn Signal Light & Hazard Light UnitREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable fro ...

Dtc c0038 rl pressure reducing valve malfunction
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0038 RL PRESSURE REDUCING VALVE MALFUNCTIONNOTE:For the diagnostic procedure, refer to “C0064 NORMAL CLOSING VALVE 2 MALFUNCTION”. Diagnostic Procedure with Diagnostic Trouble C ...