Subaru Crosstrek Service Manual: Removal

1. RADIO/TELEMATICS ANTENNA

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the trim panel - roof assembly. Roof Trim > REMOVAL">

3. Remove the antenna assembly - radio or telematics.

(1) Disconnect the connector and terminal, and remove the mounting nut (A).

(2) Pull out the antenna assembly - radio or telematics from the roof panel top.

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the trim panel - roof assembly. Roof Trim > REMOVAL">

3. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

4. Remove the glove box. Glove Box > REMOVAL">

5. Remove the center grille assembly. Air Vent Grille > REMOVAL">

6. Remove the audio assembly or navigation assembly. Audio > REMOVAL">

7. Turn over the floor mat. Floor Mat > REMOVAL">

8. Remove the cord assembly - antenna feeder.

Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”.

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver and the knee airbag module. Knee Airbag Module > REMOVAL">

3. Remove the glove box. Glove Box > REMOVAL">

4. Remove the center grille assembly. Air Vent Grille > REMOVAL">

5. Remove the audio assembly or navigation assembly. Audio > REMOVAL">

NOTE:

The data communication module will be removed at the same time.

6. Remove the combination meter assembly. Combination Meter > REMOVAL">

7. Remove the GPS antenna.

NOTE:

Remove the antenna only. Do not pull the cord.

8. Remove the telematics sub antenna.

(1) Disconnect the telematics sub antenna connector on the data communication module side, and tie a string to the connector.

NOTE:

A string makes operation easier during installation.

(2) Remove the screw and harness clamp, and pull out the telematics sub antenna from the combination meter side.

(3) After the telematics sub antenna has been pulled out, remove the string attached to the connector in step (1).

Installation

Audio

Other materials:

Help line
The help line (distance marker and vehicle width line) is a guide to help you realize the actual distance from the screen image. 1) Vehicle width line (oblique vertical line) 2) Approx. 10 feet (3 m) from the bumper (green horizontal line) 3) Approx. 3 feet (1 m) from the bumper (yellow hor ...

Suspension
SPECIFICATIONS > CrosstrekSUSPENSIONModel2.0 L DOHC non-turboFrontMacpherson strut type suspensionRearDouble-wishbone type suspension ...

Component
CONTROL SYSTEMS > General DescriptionCOMPONENT1. AT SELECT LEVER(1)Grip sub ASSY (model with gate shifter)(14)Spacer pin guide(27)Nut(2)Clamp grip pin(15)Plate COMPL(28)Button ASSY-AT(3)Cover grip AT (model with gate shifter)(16)Shaft control(29)Housing(4)Rod COMPL(17)Spacer pin guide(30)Blind A ...