Subaru Crosstrek Service Manual: Removal
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Rear Catalytic Converter
REMOVAL
The rear catalytic converter is integrated into the center exhaust pipe; therefore, refer to “Center Exhaust Pipe” for the removal procedure. Center Exhaust Pipe > REMOVAL">
Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Rear Catalytic ConverterINSPECTION1. Check the connections and welded parts for exhaust leaks.2. Make sure there are no holes or rusting. ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Rear Catalytic ConverterINSTALLATIONThe rear catalytic converter is integrated into the center exhaust pipe; therefore, refer to “Cent ...
Other materials:
Installation
DRIVE SHAFT SYSTEM > Front AxleINSTALLATION1. Install the front drive shaft assembly.CAUTION:• Do not hammer the drive shaft assembly when installing.• Use new axle nuts.(1) Insert the drive shaft assembly into the hub spline, and pull it into the specified position.(2) Tighten the ax ...
Control unit Note
CRUISE CONTROL SYSTEM > Control UnitNOTESystem control of the cruise control is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine Control Module (ECM)">• Transmission control module (TCM): Transmission Control Modu ...
Removal
EXTERIOR BODY PANELS > Rear GateREMOVALCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. REAR GATE PANEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REM ...
