EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV Valve
REMOVAL
CAUTION:
Do not remove unless the PCV valve is broken.
1. Disconnect the PCV hose from the intake manifold and the PCV valve, and then remove the PCV hose.
2. Remove the clip (A) holding the air breather hose from the engine hanger. (MT model)
3. Disconnect the connector (B) from manifold absolute pressure sensor. (MT model)
4. Disconnect the connector (C) from the throttle position sensor. (MT model)
5. Disconnect the connector (D) from the EGR control valve. (MT model)
6. Remove the PCV valve from the cylinder block RH.
Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Low tire pressure warning light (type A)
Low tire pressure warning light (type B)
The tire pressure monitoring system provides
the driver with the warning message
indicated by sending a signal from a
sensor that is installed in each wheel
when tire pressure is severely low.
The tire ...
Disabling keyless access function
WARNING
If you wear an implanted pacemaker
or an implanted defibrillator, perform
the procedure described in
"By operating the driver's door"
2-18 to disable the keyless access
function. If you perform the procedure
described in "By operating the
access key" 2-18, the operation of
an implan ...
Dtc b2a02 tel2 antenna circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A02 TEL2 ANTENNA CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the followings continues for 5 seconds or more.• TEL2 impedance is more than 1 M?. (Deta ...