Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain Separator

REMOVAL

The drain separator is installed to the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal procedure. Leak Check Valve Assembly > REMOVAL">

Assembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorASSEMBLYAssemble in the reverse order of disassembly.NOTE:Connect the quick connector as shown in the figure. ...

Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain SeparatorDISASSEMBLY1. Disconnect the drain tube (A) from the leak check valve assembly.NOTE:Disconnect the quick connector as shown i ...

Other materials:

Component
IGNITION(H4DO) > General DescriptionCOMPONENT(1)Spark plug(2)Ignition coilTightening torque: N·m (kgf-m, ft-lb) T1:8.5 (0.9, 6.3) T2:17.5 (1.8, 12.9) ...

Inspection
LIGHTING SYSTEM > Spot Map LightINSPECTION1. SPOT MAP LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it is found defective.2. SPOT MAP LIGHT SWITCH1. Check the resistance between switch ter ...

Disassembly
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof AssemblyDISASSEMBLY1. Remove the screw and remove the sunroof motor.2. Remove the stopper rubber and pull out the sunshade assembly from the rail assembly - sunroof.3. Disconnect the claws and then remove the drain holder.4. Remove the screw and p ...

© 2016-2025 Copyright www.sucross.com