Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

DRIVE SHAFT SYSTEM > Front Drive Shaft

REMOVAL

1. Lift up the vehicle, and then remove the front wheels.

2. Remove the axle nut.

CAUTION:

Do not loosen the axle nut while the front axle is loaded. Doing so may damage the hub unit bearing.

(1) Lift the crimped section of axle nut.

(2) Remove the axle nut using a socket wrench while depressing the brake pedal.

3. Drain the transmission gear oil. (MT model)

4. Drain differential gear oil. (CVT model)

5. Disconnect the ball joint assembly.

(1) Remove the nut and disconnect the front stabilizer link.

(2) Remove the bolts, disconnect the front arm ball joint, and lower the front arm assembly.

6. Remove the front drive shaft assembly from the front axle housing.

NOTE:

If it is hard to remove, use the ST.

Preparation tool:

ST1: AXLE SHAFT PULLER (926470000)

ST2: AXLE SHAFT PULLER PLATE (28099PA110)

7. Using a bar, remove the front drive shaft assembly from transmission.

CAUTION:

Be careful not to allow the bar to damage holder area.

Assembly
DRIVE SHAFT SYSTEM > Front Drive ShaftASSEMBLY1. Roll up a thick piece of paper to a size where the shaft can pass through, and affix with tape to form a cylinder.2. Attach a new O-ring on this cyl ...

Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remov ...

Other materials:

Installation
MECHANICAL(H4DO) > Cylinder BlockINSTALLATION1. Apply engine oil to the crankshaft bearing, and install the crankshaft bearing to the cylinder block.CAUTION:• Place a wood board wrapped with a waste cloth to prevent the knock pin damage and to stabilize the cylinder block before work.• ...

Dtc p0204 cylinder 4 injector "a" circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0204 CYLINDER 4 INJECTOR "A" CIRCUITNOTE:For the diagnostic procedure, refer to DTC P0201. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0201 CYLINDER 1 INJECTOR "A" C ...

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorINSPECTION1. CAMSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.• Intake camshaft position sensor• E ...

© 2016-2022 Copyright www.sucross.com