Subaru Crosstrek Service Manual: Removal
DIFFERENTIALS > Rear Differential Front Member
REMOVAL
1. Disconnect the ground cable from battery.
2. Lift up the vehicle.
3. Support the rear differential using transmission jack, and then remove the rear differential front member.
(A) | Rear differential front member |
Inspection
DIFFERENTIALS > Rear Differential Front MemberINSPECTION1. Check the rear differential front member for damage, bend and corrosion.If damage, bend or corrosion is excessive, replace the rear differ ...
Installation
DIFFERENTIALS > Rear Differential Front MemberINSTALLATION1. Install the rear differential front member, and temporarily attach and tighten a new self-locking nut.2. Remove the transmission jack.3. ...
Other materials:
General description
DIFFERENTIALS > Rear Differential Inspection ModeGENERAL DESCRIPTIONCAUTION:Be sure to perform rear differential inspection mode.• Follow the messages displayed on the Subaru Select Monitor when working.• “Rear differential inspection mode” using the Subaru Select Monitor ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater CoreREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Using the refrigerant recovery syste ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
