Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Removal

CRUISE CONTROL SYSTEM > Cruise Control Command Switch

REMOVAL

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Set the tire to the straight-ahead position.

2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

3. Remove the driver’s airbag module. Driver’s Airbag Module > REMOVAL">

4. Remove the steering wheel. Steering Wheel > REMOVAL">

5. Remove the cruise control command switch assembly. Steering Wheel > DISASSEMBLY">

Inspection
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 9C ...

Cruise control system
...

Other materials:

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission CaseINSTALLATION1. Clean the mating surface of transmission case and converter case.2. Select the reduction gear shim. Reduction Drive Gear > ADJUSTMENT">3. Remove the transmission case, and install the selected reduction gear s ...

Dtc c1711 steering angle sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1711 STEERING ANGLE SENSORDTC detecting condition:Defective steering angle sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not ...

Disassembly
BRAKE > Master CylinderDISASSEMBLY1. Remove the reservoir tank.CAUTION:Be careful not to tighten a vise excessively.(1) Place the master cylinder assembly between aluminum plates and fix it on a vise.(2) Drive out the pin using a punch and a hammer to remove the reservoir tank.2. Remove the seal ...

© 2016-2022 Copyright www.sucross.com